HYTEM 4 WAYS GPS SIGNAL SPLITTER WITH RF LOSSES COMPENSATION AND SATELLITE SIGNAL TRACKING INFORMATION Tiroir de répartition de Signal GPS 1575.4MHz 4 voies Type 05-02-140 CARACTERISTIQUES TECHNIQUES ET UTILISATION TECHNICAL SPECIFICATIONS AND USE MAN 05-02-140 GPS signal splitter- Tiroir de répartition de signal GPS 4 voies Type 05-02-140 HYTEM TECHNICAL SPECIFICATIONS AND USE CARACTERISTIQUES ET UTILISATION Oct 2007 GARANTIE WARRANTY ! La maintenance de cet appareil doit être assurée par du personnel qualifié muni des équipements appropriés Pour tout problème de maintenance, veuillez contacter notre Service Clients : The maintenance of this instrument can only be performed by qualified personnel provided with the suitable equipments. For any maintenance problems, contact our Customer Support Service : HYTEM 2, bis rue du Bois Fourgon 91580 VILLECONIN FRANCE Tél : (33) 01 60 80 59 00 Fax : (33) 01 60 80 33 22 Email : [email protected] MAN 05-02-140 Oct 07 GPS signal splitter- Tiroir de répartition de signal GPS 4 voies Type 05-02-140 HYTEM CARACTERISTIQUES ET UTILISATION TECHNICAL SPECIFICATIONS AND USE MAN 05-02-140 Oct 07 GPS signal splitter- Tiroir de répartition de signal GPS 4 voies Type 05-02-140 HYTEM CARACTERISTIQUES ET UTILISATION TECHNICAL SPECIFICATIONS AND USE Guide d’installation d’un tiroir de répartition GPS GPS subrack installation guide Pour assurer un fonctionnement optimal de votre installation GPS, vous devez respecter ces quelques points. To realise a good GPS intallation, you must follow these instructions Le gain, disponible au tiroir HYTEM de répartition du système GPS doit être de 20dB minimum. The minimum gain at the HYTEM GPS splitter subrack, must be, at least 20dB L’antenne, fournie présente un gain de 35dB. Il convient donc de ne pas dépasser 15dB d’atténuation du signal (coaxial) entre le tiroir et l’antenne. Our antenna gives 35dB of gain, so you must be carreful that the losses of your feeder has no more than 15dB losses between the antenna and the subrack Le tiroir de répartition GPS 4 voies présente un gain total de 25dB. Ainsi, si vous avez, à l’entrée du tiroir, un gain de ( par exemple) 24dB, le gain disponible à la sortie de ce même tiroir est de 25 + 24 = 49dB Il suffit alors de calculer la perte maximale admissible entre votre installation et le tiroir soit 49dB (gain à la sortie du tiroir) - 20dB (gain minimal à obtenir) = 29dB Les pertes dans le coaxial entre le tiroir et votre installation ne devra pas excéder 13dB. The Subrack provides a total gain of 25dB. If you have, at the antenna input (example) 24dB gain, you can easyly calculate the gain at the output of the subrack: 25 + 24 = 49dB. You can now calculate the max losses between the subrack and your GPS 49dB (output gain subrack) – 20dB (minimal gain) = 29dB Total losses (coaxial feeder) between the subrack and the installation must not exeed 15dB 1-calculate gain (Gin) at the HYTEM subrack Gin = Trimble antenna – coax antenna (A) losses In our example => Gin = 35 – 11 = 24dB 2-calculate gain (Gout) at the output of the HYTEM subrack Gout = Gin + subrack gain In our example => Gout = 24 + 25 = 49dB 3-calculate the max coax user losses (B) (equal for each output) Max coax user losses = Gout – 20 (constant) In our example => Max coax user losses = 49 – 20 = 29dB (to know the loss of a coaxial, please refer to: HYTEM RF & microwave cable assemblies) MAN 05-02-140 Oct 07 GPS signal splitter- Tiroir de répartition de signal GPS 4 voies Type 05-02-140 HYTEM CARACTERISTIQUES ET UTILISATION TECHNICAL SPECIFICATIONS AND USE UTILISATION It is very simple to use the GPS signal splitter subrack, you just need to plug the "GPS 1 input" to the antenna 5V L’utilisation du tiroir de répartition du signal GPS est simple. Il suffit de raccorder l’entrée « GPS1 input » à l’antenne 5V. When the VAC power supply is "ON" the 8 DEL on the front side are red during a short period of few second. (test) A la mise sous tension du tiroir, les 8 leds de la face avant s’illuminent puis s’éteignent. (test) The average satellite detection time is about 3 to 5 minutes. Le temps nécessaire à la détection des satellites est comprise entre 3 et 5 minutes The quantity of satellite detected is indicated by the number of red DEL on front side Le nombre de satellites en vue par le tiroir est donné par le nombre de leds allumées. The GSP signal is on all output on the subrack back side. Le signal GPS est disponible, pour chaque entrée, sur 4 sorties à l’arrière du tiroir. Toutes les 5 minutes environ, le tiroir GPS se remet à zéro, vide sa mémoire des satellites et recommence une recherche automatique. Ceci n’interfère pas sur le fonctionnement du tiroir, qui continue la distribution du signal. Every 5 minutes, The subrack is making a “reset” of his satellite memory, and begin automatic satellite recovery. When this happen, the leds could be “OFF” some seconds but the subrack is working continuously. (no signal loss). ALARM-ALARMES IF the DEL number 8 is winking for a long time = ''No satellite reception" ( please control the antenna connection or Change the antenna) LED « 8 » seule clignotante durant une longue période = pas de réception satellite (vérifier l’antenne) IF the DEL number 7 is winking more than 10 seconds = Internal subrack problem (please reset) LED « 7 » seule clignotante durant plus de 10 secondes = problème de communication interne au tiroir. (marche/arrêt) Précaution d’emploi Ne pas relier d’autres antennes au tiroir que celles fournies par HYTEM. Do not use other antennas than provided by HYTEM Si une entrée GPS n’est pas utilisée, ne rien y raccorder à l’entrée. Ne pas faire de court-circuit DC à l’entrée. If a GPS input is not used, do not connect anything. Do not DC short the input. Si le nombre de sorties n’utilise pas la totalité des 16 voies, ces dernières doivent être chargées par des « bouchons 50 Ω HYTEM » P/N : 02-02-03 ou équivalent. If you are not using all the output of the subrack, the not used outputs must loaded by 50 Ω load (HYTEM part: 02-02-03) MAN 05-02-140 Oct 07 GPS signal splitter- Tiroir de répartition de signal GPS 4 voies Type 05-02-140 HYTEM CARACTERISTIQUES ET UTILISATION TECHNICAL SPECIFICATIONS AND USE Entrée radiofréquence: Radiofrequency Input: Fréquence nominale d’entrée = 1575.4MHz (GPS) Nominal frequency input = 1575.4MHz (GPS) Connectique Connector : embase N femelle : N female Impédance : 50 ohms Impedance : 50 Ohms Niveau Max d'entrée : -20 dBm Max Level without damage : -20dBm Gain ( Port d'entrée- port de sortie ) : 24 dB min RF gain between input port and splitte port: 24 dB min Note: You must deduct the coaxial cable losses for global gain calculation. Antenne recommandée : BULLET III active 5V Recommanded antenna : BULLET III active 5V Indication de fonctionnement par leds Alarm: Leds indicators Ne jamais connecter de charge 50Ω en entrée Do not connect 50Ω load at the input Spécifications générales Température : Fonctionnement Tenue des spécifications Entrée secteur fusible (1 A) Puissance consommée General specifications Temperature : Operating : Guaranted specifications : 0 à +60 °C : +5 à +50 °C : 85-264 Vac / 50-60 Hz : < 35 W Main Voltage fuse (1 A) Power consumption : 0° to +60°C : +5° to +50°C : 85-264Vac / 50-60 Hz : < 35 W Réalisation mécanique Mechanical features Coffret métallique Dimensions extérieures : 483 x 88 x 350 mm Metal cabinet Total dimensions: 483 x 88 x 350 mm MAN 05-02-140 Oct 07 GPS signal splitter- Tiroir de répartition de signal GPS 4 voies Type 05-02-140 HYTEM CARACTERISTIQUES ET UTILISATION TECHNICAL SPECIFICATIONS AND USE MAN 05-02-140 Oct 07 ">
Public link updated
The public link to your chat has been updated.