Casio SE-C3500 Mode d'emploi

To change the paper roll, follow these steps, depending on the type of paper (ticket or statement):

• For ticket paper:

  1. Remove the printer cover.
  2. Open the ticket printer cylinder arm (on the left) by lifting it.
  3. Insert the roll into the space behind the printer making sure that the paper is fed from the bottom of the roll.
  4. Place the leading edge of the paper over the printer.
  5. Slowly close the cylinder arm until it locks into place.
  6. Replace the printer cover, passing the leading edge of the paper through the slot. Tear off the excess paper.

• For statement paper:

  1. Proceed as for ticket paper setting to set the statement paper on the statement printer.
  2. Feed the paper at least 20 cm with the j key.
  3. Remove the paper guide from the receiving reel.
  4. Slide the leading edge of the paper into the groove on the receiving reel pivot and wind it onto the reel two or three turns.
  5. Replace the receiving reel paper guide.
  6. Insert the receiving reel behind the printer, above the paper roll.
  7. Press the j key to fully tension the paper.
  8. Replace the printer cover.

To turn off the cash register, turn the mode selector to the OFF position.

To change the paper roll, follow these instructions, which differ slightly depending on whether it is ticket paper or statement paper:

Installing ticket paper:

1. Remove the printer cover.
2. Open the ticket printer cylinder arm (on the left) by lifting it.
3. Insert the roll into the space behind the printer, ensuring that the paper is fed from the bottom of the roll.
4. Place the leading edge of the paper over the printer.
5. Slowly close the cylinder arm until it locks into place.
6. Replace the printer cover, passing the leading edge of the paper through the slot. Tear off excess paper.

Installing statement paper:

1. Proceed as for setting the ticket paper to set the statement paper on the statement printer.
2. Feed the paper at least 20 cm with the j key.
3. Remove the paper guide from the receiving reel.
4. Slide the leading edge of the paper into the groove on the receiving reel pivot and wrap it around the reel two or three times.
5. Replace the receiving reel paper guide.
6. Insert the receiving reel behind the printer, above the paper roll.
7. Press the j key to fully tension the paper.
8. Replace the printer cover.

To program the device, the selector must first be placed in "PGM" mode. After this, several configurations are available.