Information produit | Kolpak Condensing Unit Single Phase Manuel utilisateur

Ajouter à Mes manuels
1 Des pages
Information produit | Kolpak Condensing Unit Single Phase Manuel utilisateur | Fixfr
 CONNECT INCOMING POWER LEADS FROM DISCONNECT SWITCH
TO L1, AND L2, CONSISTANT WITH NAMEPLATE VOLTAGE AND
FREQUENCY. USE COPPER CONDUCTORS ONLY.
208-230/1/60
L1 L2 G
| | | FACTORY WIRING
| | — — — FIELD WIRING
| | | HIGH PRESSURE LOW PRESSURE
CONTROL SWITCH CONTROL SWITCH
“| 2
~ GROUND
| © screw = СТ
: ОГ
: ml
À TV A
1 | ORANGE
ORANGE
en, BLUE or RED or GRAY
T ТР © AN BLUE or RED or GRAY
O, OU XP ——
LA
START = ANA BLACK OC
CAPACITOR | CAPACITOR | Л А ANA BLUE A OS
BLACK A NT RED / OR
v
RED Mm
EXTERNAL OVERLOAD
BLACK = (If required, wired in series
— in common line.)
> COMPRESSOR TERMINAL BOX
BLACK e ELLOW A BLACK
BLACK
< > CONDENSING UNIT CRANKCASE
ELECTRICAL BOX HEATER
_ (IF REQUIRED)
TO) (SF
CONDENSER FAN CYCLE
FAN CONTROL SWITCH
(IF REQUIRED)
WIRING DIAGRAM 208-230/1/60

Manuels associés