REAR PANEL Next
Sending an order signal instantly fades the modulation in the headphones.
The order signal routing can be set up via hardware jumpers (internal): either directly to headphone 1 or to all headphones
Order Signal Routing Set-up
JP 1 and JP 2
POSITION A :
Order signal sent with fade in headphones 1 to 6.
POSITION B :
Order signal sent with fade only to headphone 1.
As default, the AMC610 is configured with jumpers in position A
INFORMATION
Warning
AMC610 mains connector has three wires (2 poles + earth). Earth should imperatively be connected to mains earth.
Never use this equipement without proper grounding.
Check quality of grounding.
Should noise or hum occurs when connected to other equipments, never disconnect grounding, use insulating transformer on mains.
Never open the case without disconnecting mains
Avoid high temperature exposure.
Never expose the equipment to rain, snow or moisture.
Using AMC610 headphone amplifier, listening to high level can result in permanent damage to ears.
AMC 610 complies with :
EN60065, EN55013, EN55020, EN60555-2, and EN60555-3, according to 73/23/EEC, 89/336/EEC et 93/68/EEC.
Rami
13
AMC610
