OPERATING LEVELS
3 - CONFIGURING THE CONTROL UNIT LMU VIA THE QAA73
After setting the parameters via the QAA 73 room sensor (for the 4./5. et 6. Levels), and so that the LMU accepts the modifications to the
3.1 - 4. Level : Parameter settings for the end-user
Enter the control unit LMU via the sensor QAA73 and first level settings.
settings, press the RESET button on the boiler control panel, wait for 6 seconds and press a second time.
Line
1
Buttons Explanation
Press on the both line selection buttons and setting buttons beginning with the button .
- This will take you to the first programming mode "LMU"(4. level)
Successive display:
P ROG
et
2
P ROG
b)
Press the line selection buttons to select the required line.(rep. b).
- All possible lines are indicated in § 2 - section IV - Parameter list
3
4 c)
. . .
Press the plus or minus button to enter the required value (rep. c). The setting will be stored as soon as you leave the programming mode or change to another line.
- The parameter list containing all possible settings is indicated in § 2 - section IV
- Parameter list
By pressing the Info button, you leave the programming mode "end-user"
Permanent display
- 7 -
