OPERATING LEVELS
2 - 2. LEVEL : PARAMETER SETTINGS FOR THE HEATING ENGINEER
Room unit configuration and parameter settings of the room sensor to be made by the heating engineer.
Buttons Explanation
Press one of the 2 line selection buttons.
- This will take you to the programming mode "End-user”. (1. level)
Display :
1
P ROG
Line
2
3
4
5
Press both line selection buttons for at least 3 seconds.
- This will take you to the programming mode "Heating engineer" (2. level)
Display :
P ROG
a) b)
a) Line name b) Line number c) Setting of the parameter
Press the line selection buttons to select the required line.(rep. b).
- All possible lines are indicated in § 1.2 - section IV - Parameter list
P ROG
c)
. . .
Press the plus or minus button to enter the required value (rep. c). The setting will be stored as soon as you leave the programming mode or change to another line.
- The parameter list containing all possible settings is indicated in § 1.2 - section
IV - Parameter list
By pressing the Info button, you leave the programming mode "Heating engineer"
Permanent display
- 6 -
