Installation (Seuls les installateurs qualifiés)
17
Installation du panneau
PANEL SIZE
Arched (8” x 10”)
10” x 13” Rectangular
WIDTH HEIGHT
40-3/8" 28-7/8"
44-3/8" 31-7/8"
PART #
98500605
96100302
NOTE: The insert may be installed without surround panels.
NOTE: The insert may be installed without surround panels.
1 Follow the directions to the right to install the side panels.
2 Follow the directions below to install the top panel.
b
Line up each side surround panel and insert two screws from the inside to secure in place.
a
Pre-thread the holes on the surround panels with the screws included in the surround panel kit.
5/16" Nutdriver
Run the power cord to the right of the insert.
a
Install the top panel so the tabs insert into the joggle clips on the top panel
Top
Panel
Top Trim
3 If you are not using the optional blower, install the button plug into the surround panel trim to conceal the circular hole (the square hole accepts the on/off switch – see the following page).
© Travis Industries 4101216
Micro (1/16”)
Standard
Screwdriver
b
Spring
Clips
Top Trim
"L" Bracket
Right Side
Trim
"L" Bracket
Right Side Trim
Trim Installation:
Insert one leg of each "L" bracket into the top and side trim piece. Align the trim to form a precise corner, then tighten the two set screws with a small standard screwdriver.
Slide the trim over the panels. Place the spring clips behind the panels at the locations shown. This keeps the trim tight against the panel.
Optional Knock-Out
An optional knock-out is provided if the power cord is routed behind the surround panel.
100-01232FR
