Spektrum NX8 8 Channel DSMX Transmitter Only Manuel utilisateur

PDF Download
Document
Spektrum NX8 8 Channel DSMX Transmitter Only Manuel utilisateur | Fixfr

User questions

N D

Linda N.

How to mix the throttle channel with the gear channel?
No votes
Mixing allows a control input on one channel to affect multiple channels simultaneously. To mix the throttle channel with the gear channel, follow these general steps based on the mixing functionality described in the document: 1. **Access the mixing menu:** Select a new programmable mix in the mixing menu. You can choose between a normal mix or a curve mix. 2. **Configure the mix:** On the second line of the mixing menu, select the throttle channel as the master control on the left and the gear channel as the slave control on the right. This means that the throttle channel inputs will control both the throttle and gear channels. 3. **Adjust the Rate:** Modify the rate value to control the travel and direction of the slave channel (gear). A positive or negative value can be used to reverse the direction if necessary. 4. **Adjust the Offset:** If you need to move the effective center position of the slave channel (gear), adjust the offset value. Note that offset is not available for curve mixes. 5. **Enable Trim:** If you want the throttle channel trim to also affect the gear channel, set the trim to Act. 6. **Select a switch:** Choose the switch you want to use to activate the mix, or select ON if you want the mix to be active permanently. After setting up the mix, it is important to test the controls of your model to ensure it responds correctly to commands and that the mix is working as expected. Note: Since there is no information about specific device in the manual, these explanations are of a general nature. There is a risk of incompatibility of some arguments in relation to your device.
N D

Linda N.

How to mix the throttle channel with the gear channel while maintaining the motor cut function?
No votes
To mix the throttle channel with the gear channel while maintaining the motor cut (throttle cut) function, you will need to configure both a mix and the motor cut function separately. 1. **Mixing the throttle and gear channels:** * Access the mixing menu of your transmitter. * Create a new mix where the throttle channel is the source (master) and the gear channel is the destination (slave). * Adjust the mixing percentage (rate) as needed. This will determine how the gear channel responds to changes in the throttle channel. 2. **Configuring the motor cut:** * Go to the motor cut (Throttle Cut) menu of your transmitter. * Make sure the motor cut is activated and assigned to a specific switch. * Verify that the motor cut position is properly set to cut the motor. It is important to note that the motor cut function must be configured to override any other mixes affecting the throttle channel when activated. This will ensure that the motor can be safely cut, even if other mixes are active. Note: Since there is no information about specific device in the manual, these explanations are of a general nature. There is a risk of incompatibility of some arguments in relation to your device.
Preparing document for printing…
0%