Castorama HJDXK15GT46S Manuel utilisateur

PDF
Document
Radiateurs J10JDX8LU, J15JDX8LU: Mode d'emploi + AI | Fixfr
/

User questions

H S

John H.

How to configure and connect the pilot wire?

To use the pilot wire:

  1. Electrical connection: Connect the phase (brown), neutral (blue), and pilot wire (black). Do not connect the pilot wire to ground; if it is not connected, insulate its bare end.
  2. Control side: Connect the pilot wire to the electrical system's pilot wire manager or a compatible radio module.
  3. On the heater: Select the FIL.PI mode using the mode selection button, then confirm with OK.
H S

John H.

How to configure the pilot wire?

To configure the pilot wire:

  1. Electrical connection: Connect the phase (brown), neutral (blue), and pilot wire (black). Do not connect the pilot wire to earth; if not connected, insulate its stripped end.
  2. Control: Connect the pilot wire to the pilot wire manager of the electrical installation or a compatible radio module.
  3. Radiator settings: Select FIL.PI mode using the mode selection button, then confirm with OK.
H S

John H.

How to configure and connect the pilot wire on the radiator?

To configure and connect the pilot wire:

  1. Electrical connection: Connect the phase (brown), neutral (blue), and pilot wire (black). Do not connect the pilot wire to earth; if unused, insulate its stripped end. The device must not be plugged into a standard wall socket.
  2. Control unit: Connect the pilot wire to the electrical installation's pilot wire manager or a compatible radio module.
  3. Radiator configuration: Select FIL.PI mode using the mode selection button, then confirm with OK.
H S

John H.

How to connect and configure the pilot wire on a radiator?

  1. Electrical connection: Connect the phase (brown), neutral (blue), and pilot wire (black). Do not connect the pilot wire to earth; if left unused, insulate its stripped end.
  2. Control side: Connect the pilot wire to the electrical system's pilot wire manager or a compatible radio module.
  3. On the radiator: Select the FIL.PI mode using the mode selection button, then confirm with OK.
H S

John H.

How to configure the pilot wire on a radiator?

  1. Connect the phase (brown), neutral (blue), and pilot wire (black). Do not connect the pilot wire to earth.
  2. Connect the pilot wire to the electrical installation's pilot wire manager or a compatible radio module.
  3. On the radiator, select FIL.PI mode using the mode selection button, then confirm with OK.
Preparing document for printing…
0%