How to perform the electrical connections for the LUXA 101-360 motion detector?
The device uses a plug-in base with terminals for the phase (L), neutral (N), and the load (Last). Cables are introduced through the bottom or rear of the device using rubber grommets. The detector supports standard installation, configurations with a manual switch or changeover switch, and multi-detector setups to control a single load.
How to perform a standard installation and adjustment of the LUXA 101-360 detector?
The detector is designed for wall or ceiling mounting using a plug-in base with captive screws. For corner mounting, an optional corner bracket can be used. After mounting, three potentiometers located under the sensor allow for the adjustment of the light threshold (Lux), lighting duration (Time), and detection range (Meter).
How to connect the LUXA 101-360 detector when phase, neutral, and earth wires are present?
Connect the phase (L) and neutral (N) wires to their respective terminals on the device. The load is connected via the D1 D2 switching relay output. The device is classified as protection Class II (reinforced insulation) and does not require a connection to an earth (PE) wire.
How to wire the LUXA 101-360 detector?
The LUXA 101-360 detector is wired using a plug-in base with terminals. Standard installation uses the L (Phase), N (Neutral), and Last (Charge) terminals. It can also be configured with a manual switch or with multiple detectors controlling a single load.
How to install and adjust the LUXA 101-360 detector?
The device is mounted on a wall or ceiling using a plug-in base. Adjustments for the brightness threshold (Lux), lighting duration (Time), and detection range (Meter) are made using three potentiometers located under the sensor.
How to connect Phase, Neutral, and Ground wires to the LUXA 101-360 detector?
Connect the Phase wire (L) to terminal L and the Neutral wire (N) to terminal N. Since the device is Class II (reinforced insulation), the ground wire is not connected to the device itself.
How to wire the LUXA 101-360 detector?
The detector features a plug-in base with screwless terminals for quick connection. For a standard installation, connect the Phase (L), Neutral (N), and the Load (Last). Cables can be inserted from the bottom or the back of the device using the provided rubber grommets. Specific configurations allow for manual switches or the use of two detectors for a single load.
How to perform a standard installation and adjustment of the LUXA 101-360 detector?
The device is designed for wall or ceiling mounting and uses a plug-in base with screwless terminals. After mounting the base and connecting the cables through the rubber grommets, you can adjust the light threshold (Lux), lighting duration (Time), and detection range (Meter) using the three potentiometers located under the sensor.
How to connect the LUXA 101-360 detector when Phase, Neutral, and Earth wires are present?
Connect the Phase (L) wire to the L terminal and the Neutral (N) wire to the N terminal. No connection is required for the Earth (PE) wire because the device is classified as Class II protection (reinforced insulation), meaning it does not require a safety ground connection when installed correctly.
How to wire the LUXA 101-360 detector?
The LUXA 101-360 uses a plug-in base with terminals. Cables can be introduced through rubber grommets from the bottom or back of the device. Supported configurations include standard installation (using L, N, and Load terminals), setups with manual switches, or connecting two detectors to a single load.
How to install the LUXA 101-360 detector?
The detector is designed for wall or ceiling mounting using provided screws and a plug-in base with screwless terminals. An optional bracket is available for corner mounting. Three potentiometers located under the sensor allow for adjusting the light threshold (Lux), lighting duration (Time), and detection range (Meter).