Gardena 1739 Manuel utilisateur

PDF
Document
GARDENA 1739: Mode d'emploi | AI Chat & PDF Access | Fixfr
/

User questions

Z S

Jennifer Z.

How to mount the electronic pressure switch?

To mount the electronic pressure switch on your pump, follow these steps: 1. Preparation: Make sure to use the adapter for specific GARDENA models (ref. 1422, 1429, 1432, 1434, 1438, 1442) by screwing the adapter to the pump and the cap to the lateral discharge connection. 2. Installation: Mount the switch on the pump. 3. Fixation: Hold the switch with one hand and screw the lower rotating part into the pump until it stops. 4. Adjustment: Once it stops, turn the check valve backward (maximum 1 turn) to reach the desired position. 5. Electrical connection: Plug the pump's plug into the socket located at the back of the switch's display.

Z S

Jennifer Z.

How to mount an electronic pressure switch on a pump?

Attach the specific adapter to the pump and the discharge connection. Screw the lower rotating part of the switch into the pump until it stops. Adjust the check valve by turning it back a maximum of one turn to the desired position. Connect the pump's plug to the socket located on the back of the switch display.

Z S

Jennifer Z.

How to install the electronic manometric switch on a pump?

To install the switch, first use an adapter for specific GARDENA models by screwing it to the pump. Mount the switch onto the pump and screw the lower rotating part in until it stops. Then, turn the check valve backward (maximum 1 turn) to the desired position. Finally, connect the pump's plug to the socket at the back of the switch display.

Z S

Jennifer Z.

How to install an electronic pressure switch on a compatible pump?

Using the specific adapter for compatible models, screw the adapter to the pump and the cap to the lateral discharge port. Mount the switch on the pump and tighten the rotating part until it stops. If necessary, rotate the check valve back by up to one turn to adjust its position, then connect the pump to the socket on the back of the switch display.

Z S

Jennifer Z.

How to install an electronic pressure switch on a pump?

For compatible GARDENA models, screw the adapter to the pump and the cap to the lateral discharge connection. Mount the switch on the pump and screw the lower rotating part until it stops. Then, turn the non-return valve back (maximum 1 turn) to the desired position. Connect the pump plug to the socket at the back of the switch display.

Preparing document for printing…
0%