Bul. 140G
140G-NTK-E12
LSIG-MM Trip unit installation 140G-N, 140G-NS
Sganciatore elettronico a microprocessore LSIG-MM e moduli
Elektronischer Mikroprozessor-Auslöser und Module LSIG-MM
Déclencheur électronique à microprocesseur et modules LSIG-MM
Relé electrónico con microprocesador y módulos LSIG-MM
Installation - Installazione - Instalación
Instalação WARNING: To prevent electrical shock, disconnect from power source before
installing or servicing. Install in suitable enclosure. Keep free from contaminants.
(Follow NFPA70E requirements).
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell'installazione o
manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.
(Seguire i requisiti NFPA70E).
WARNUNG: Vor Installations- oder Servicearbeiten Stromversorgung zur
Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem
passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden. (Befolgen
Sie die Anforderungen nach NFPA70E).
AVERTISSEMENT: Avant le montage et la mise en service, couper l'alimentation
secteur pour éviter toute décharge. Prévoir une mise en coffret ou armoire appropriée.
Protéger le produit contre les environnements agressifs. (Vous devez respecter la
norme NFPA70E).
ADVERTENCIA: Desconéctese de la corriente eléctrica, antes de la instalación o
del servicio, a fin de impedir sacudidas eléctricas. Instálelo en una caja apropiada.
Manténgalo libre de contaminantes. (Cumpla con los requisitos NFPA70E).
ATENÇÃO: Para evitar choques, desconectar da corrente elétrica antes de fazer a
instalação ou a manutenção. Instalar em caixa apropriada. Manter livre de
contaminantes. (Cumpra as exigências da norma NFPA70E).
140G-N
1
2
140G-NS
2
x1
1
x10
140G-NS
x2
x1
140G
x2
x2
IF USED
DIR 1000529R0503 (L6151)
COMMUNICATION MODULE OPTIONAL
IF USED
1
2
1
1
2
DIR 1000529R0503 (L6151)
4p ONLY
(2)
4
3
ONLY FOR 140G-NS
ONLY FOR 140G-N
5
2
1
6.19 lb-in
0.7 Nm
DIR 1000529R0503 (L6151)
(3)
6
7
8
9
1
1
2
2
DIR 1000529R0503 (L6151)
(4)
11
WITHOUT COMMUNICATION MODULE
13
WITH COMMUNICATION MODULE
10
1
2
12
WITH COMMUNICATION MODULE
1
2
DIR 1000529R0503 (L6151)
(5)
14
140G-NS
1
1
2
DIR 1000529R0503 (L6151)
(6)
140G-NS
15
2
1
9.73 lb-in
1.1 Nm
3
140G-N
16
1
1
2
DIR 1000529R0503 (L6151)
(7)
17
140G-NS
18
FOR COMMUNICATION MODULE ONLY
3
if mounted
se montato
falls montiert
s'il est monté
si está montado
2
3
1
9.73 lb-in
1.1 Nm
2
1
140G-NS
19
WITH COMMUNICATION MODULE ONLY
20
DIR 1000529R0503 (L6151)
(8)
21
WITH COMMUNICATION MODULE ONLY
(4p)
(4p)
2
1
1
(3p)
22
(3p)
2
1
DIR 1000529R0503 (L6151)
(9)
140G-NS
23
T5 95S W1 K14 K1
T6 98S W2 K15 K2
DIR 1000529R0503 (L6151)
(10)
24
42A
+
Uaux.
24V
K2
98S
K1
K2
98S
K2
64
61
Q/5
XR11
S51/MM
K51
2
XR11
63
K1
98S
K1
3
XR11
OUT MM
W4
W3
W4
LSIG-MM
95S
K14
K15
W4
W3
DIALOGUE
UNIT
W3
1
95S
95S
W1
W2
OUT MM
INTERNAL
USE
ONLY
(A)
+
(A) (B)
W2
(B)
W1
24V
MM IN
-
(MODBUS)
K51
>
>>
>>
PE
>>>
N
>>
LSl/-I
UI/N
* S)
T5
T5
T6
T6
* Z)
LSlG/
LSlG-MM
THREE-POLE C.BREAKER
WITH PR231/P, PR232/P, PR331/P OR PR332/P MICROPROCESSOR BASED RELEASE
INTERRUTTORE TRIPOLARE
CON SGANCIATORE A MICROPROCESSORE PR231/P, PR232/P, PR331/P O PR332/P
DREIPOLIGER LEISTUNGSSCHALTER
MIT MIKROPROZESSORGESTEUERTEM AUSLÖSER PR231/P, PR232/P, PR331/P ODER PR332/P
DISJONCTEUR TRIPOLAIRE
AVEC DECLENCHEUR A MICROPROCESSEUR PR231/P, PR232/P, PR331/P OU PR332/P
5.31 lb-in
INTERRUPTOR TRIPOLAR
0.6 Nm
DIR 1000529R0503 (L6151)
CON RELE CON MICROPROCESADOR PR231/P, PR232/P, PR331/P O PR332/P
(11)
25
140G-N
140G-NS
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
DIR 1000529R0503 (L6151)
Publication 140G-IN947A-MU-P - April 2013
Copyright © 2013 Rockwell Automation, Inc. All Rights Reserved.
">
