CITROEN C4 01/06/2010 - 31/12/2010 Manuel du propriétaire

PDF
Document
CITROËN C4 Clé à télécommande: Chat IA & PDF | Fixfr
/

User questions

W Z

James W.

How to replace the remote control battery?

For a 2-button remote: 1. Unclip the housing using a coin at the notch. 2. Replace the CR1620 3V battery. 3. Clip the housing back and reinitialise the remote. For a 3-button remote: 1. Unclip the cover using a small screwdriver at the notches. 2. Replace the CR2032 3V battery. 3. Clip the cover back onto the housing.

W Z

James W.

How to unfold the remote control key?

Simply press the designated button for this purpose: the key will unfold automatically. To fold it back, press the same button again before storing it.

W Z

James W.

How to open the remote control casing to change the battery?

For the 2-button remote: Unclip the casing with a coin at the notch. Slide the used battery out of its slot. Insert the new battery, respecting the original polarity (battery ref: CR1620 / 3 volts). Clip the casing. Reset the remote control. For the 3-button remote: Unclip the cover with a small screwdriver at the two notches. Lift the cover. Remove the used battery from its slot. Insert the new battery, respecting the original polarity (battery ref: CR2032 / 3 volts). Clip the cover onto the casing.

W Z

James W.

How to unfold or fold the remote control key?

To unfold the key of your remote control, simply press the dedicated button: the key unfolds automatically. To fold it back, press the same button again before storing it.

W Z

James W.

How to open the key remote casing to access its interior components or replace the battery?

The document describes opening the casing for battery replacement. For a 2-button remote: use a coin to unclip the casing at the notch, slide the old battery (CR1620 / 3 volts) out, insert the new battery, clip the casing, and reset. For a 3-button remote: use a small screwdriver to unclip the cover at the two notches, lift the cover, remove the old battery (CR2032 / 3 volts), insert the new battery, and clip the cover back onto the casing. Caution: While this procedure allows access to the interior, it is specifically for battery replacement. Accessing the circuit board itself is not detailed in the document. Tampering with the sensitive high-frequency system can disable it.

W Z

James W.

How to open the remote control key to access its internal circuit board?

To access the interior of the remote control (where the circuit board is located), the document describes the procedure for changing the battery. This involves:

  • 2-button remote: Unclipping the casing with a coin at the notch, sliding out the old battery (CR1620 / 3 volts), inserting the new one, clipping the casing, and reinitializing.
  • 3-button remote: Unclipping the cover with a small screwdriver at the two notches, lifting the cover, removing the old battery (CR2032 / 3 volts), inserting the new one, and clipping the cover back. It is important to note that manipulating the remote's sensitive high-frequency system in ways not described could render it inoperative, requiring reinitialization.
Preparing document for printing…
0%