WAVLINK Outdoor Point d'accès Wi-FI AC600 Manuel utilisateur

PDF Download
Document
Wavlink WL-WN570HA1/HN2: Chat IA & Téléchargement PDF | Fixfr

User questions

C V

Michael C.

How to change the IP address?
No votes
I am sorry, but the viewed document does not provide information on how to change the IP address of the device. Changing the IP address can vary greatly depending on your specific network configuration and the type of device. It is strongly recommended that you consult your router's user manual or contact your Internet service provider for specific instructions. Incorrect IP address configuration can cause connectivity issues.
M G

James M.

What are the differences between AP (Access Point) and Repeater modes?
No votes
In AP (Access Point) mode, the device connects to a wired network and converts it to a wireless internet access point, which can then be shared among multiple devices. In Repeater (bridge) mode, the device copies and strengthens an existing wireless signal to extend its coverage, suitable for larger areas with weak signals.
M G

James M.

When using AP mode, is a specific password required for each device to share the network?
No votes
The document indicates that you can set up a password for your extended network in AP mode. After selecting the security type (e.g., WPA/WPA2), you enter a password to secure your Wi-Fi network. All devices connecting to this network will need to use this same password. The document does not mention individual passwords for each device.
M G

James M.

If a device connects to the Wi-Fi network via the repeater in AP mode using the configured password, will it have access to the Ethernet network?
No votes
If a device connects to the Wi-Fi network via the repeater using the configured password, it will have access to resources shared on that Wi-Fi network. Access to the Ethernet network depends on the configuration of the connected box and how the Wi-Fi and Ethernet networks are isolated or connected. It is important to configure the box's security correctly to protect the Ethernet network.
Preparing document for printing…
0%